Table of Contents
Advertisement
User Guide
F.2 iSCSI Setup Tool
Run the iSCSI Setup Tool on an application server to configure the iSCSI settings required for the
application server. Before starting the following section, you need to install the NEC Storage Manager
Agent Utility. See
Agent Utility.
1. Run the following script on the application server.
# iSMiSCSISetup.sh
2. When a list of serial numbers is shown as follows, enter a list number corresponding to the serial
number of the disk array unit you want to configure.
1) 0000000991000001
2) 0000000991000002
3) 0000000991000003
4) 0000000991000004
Please select serial number.
3. The following message appears to confirm whether to use CHAP authentication. Enter y to use the
CHAP authentication. Enter n to skip the CHAP authentication.
To use CHAP authentication, please enter 'y'. [y/n]
4. When n is entered to skip the CHAP authentication, proceed to step (9). When y is entered to use
the CHAP authentication, the following message appears. Enter the password of the CHAP initiator.
Please enter the target CHAP secret.
5. To confirm, enter the password of the CHAP initiator again.
Please enter password again.
6. This is to confirm whether to use mutual CHAP authentication. Enter y to use the mutual CHAP
authentication. Enter n to skip the mutual CHAP authentication.
To use mutual CHAP authentication, please enter 'y'. [y/n]
7. Proceed to step (9) when n is entered to skip the CHAP authentication. If y is entered to use the
mutual CHAP authentication, the following message appears. Enter the password of the CHAP
target.
Please enter the initiator secret.
Release 6.0
Section D.1.1: Overview
Appendix F How to Set/Check Application Server (Linux) (iSCSI)
for details on how to install the NEC Storage Manager
393
Advertisement
Table of Contents
Troubleshooting
