User Guide
4. Return to the Connect To Target dialog box, and then click the OK button.
5. Confirm that the status of the target disk array is shown ad Connected on the Targets tab of iSCSI
Initiator Properties
To make the connection path to the disk array of a redundant configuration, select the Initiator name
(iqn) of the disk array again, click the Connect button, and then perform steps (2) to (5) described
above.
To repeat this operation, select the Enable multi-path check box in the Connect To Target dialog box.
If this check box is not selected, an error message will be displayed and connection will not be able to
established.
Release 6.0
Appendix D How to Set/Check Application Server (Windows) (iSCSI HW Initiator)
373