Table of Contents
Advertisement
User Guide
10.4 iSCSI Setup Tool Errors
10.4.1 iSCSI Setup Tool (Windows) Errors
Problem
The message, "The tool has already
been started." is displayed and the
iSCSI Setup Tool cannot be started.
The message, "The host name
should be up to 15 characters in
length. A host name can include
alphanumeric characters and
hyphens(-)." is displayed and the
iSCSI Setup Tool cannot be started.
The message, "Failed to collect the
serial number. (Error code:xxxx)" is
displayed and the iSCSI Setup Tool
cannot be started.
The message, "The tool is not set
correctly." is displayed and the iSCSI
Setup Tool cannot be started.
The message, "No management port
of the disk array is set." is displayed
and the iSCSI Setup Tool cannot be
started.
The message, "An error occurred
while reporting a log file. (Error
code:xxxx)" is displayed.
The message, "Unexpected error
occurred." is displayed.
When a serial number is entered, the
message, "No management port of
the disk array is set." is displayed.
Release 6.0
Cause and Solution
The iSCSI Setup Tool is already up and running.
Click OK to close the error message and terminate the
running iSCSI Setup Tool. Then, start the iSCSI Setup Tool
again.
Change the host name using only alphanumeric characters
or hyphen (-) based on the restrictions of creating a target.
Click OK to close the error message. After changing the
host name, restart the iSCSI Setup Tool.
An error occurred in retrieving the serial number.
Click OK to close the error message.
For details, see
Section 10.4.3: "iSCSI Setup Tool Error
Codes".
The iSCSI Setup Tool is not installed correctly.
Click OK to close the error message. Re-install the iSCSI
Setup Tool and start it again.
The management port settings of the disk array are not
configured.
Click OK to close the error message. Set the management
port and start the iSCSI Setup Tool again.
An error occurred during output of the log file.
Click OK to terminate the iSCSI Setup Tool.
For details, see
Section 10.4.3: "iSCSI Setup Tool Error
Codes".
An unexpected error occurred.
Click OK to terminate the iSCSI Setup Tool.
Do not close the error message, generate the user dump,
the event log and the log file, and contact your maintenance
service provider.
The host post connection settings are not configured.
See
Section 6.2.1: "Initialization Wizard"
initialization to configure the host connection port settings.
Then, run the iSCSI Setup Tool again.
286
Chapter 10 Troubleshooting
to perform the
Advertisement
Table of Contents
Troubleshooting
