Figure 4-16: Select A Disk Array; Table 4-3: Initialization Status Of Disk Array - NEC Storage M100 Series User Manual

User Guide
2. Click Refresh when Network Setting Tool is started.
Disk arrays detected through search are displayed.
"not set" is shown for Status for disk arrays for which network settings will be performed for the first
time.
3. Select the target disk array from the list and click Set.
If the M series has been installed and IP addresses have been configured, "finished" is shown in the
Status column. For details about information shown for the Status column, see
Status
Displayed information
not set
finished
Release 6.0

Figure 4-16: Select a Disk Array

Table 4-3: Initialization Status of Disk Array

Description
Disk array status
Disk array has just been installed
The disk array is not monitored by NEC Storage Manager
because the network settings have not been done.
IP addresses must be configured by using Network Setting Tool
IP addresses have been configured
The disk array can be monitored by NEC Storage Manager.
110
Chapter 4 NEC Storage Manager
Table 4-3.