NEC Storage M100 Series User Manual page 394

User Guide
8. To confirm, enter the password of the CHAP target again.
Please enter password again.
9. The IP addresses of the disk array are listed as follows. Enter a list number corresponding to the IP
addresses of the disk array. iSCSI Setup Tool runs a ping command using the IP addresses that are
set in the host connection port parameters. It does not show failed results and delete the failed ones
from the search result of the target.
1) Serial number=0000000991000004, Controller=0, IP
address=172.168.1.101
2) Serial number=0000000991000004, Controller=0, IP
address=172.168.1.102
3) Serial number=0000000991000004, Controller=1, IP
address=172.168.2.101
4) Serial number=0000000991000004, Controller=1, IP
address=172.168.2.102
Please select target IP address.
10.After the following message appears to confirm whether to create an LD set, enter y to proceed.
To create LD set, please enter 'y'. [y/n]
11.When the process is successfully complete, a list of the IP addresses appears as follows:
Succeed to log on to the target.
Serial number=XXXXXXXXXXXXXXXX, Controller=X, IP
address=XXX.XXX.X.XXX
The above is an example. You will actually see the serial number, controller number and IP address of
the target. You can specify a parameter file as shown below.
# iSMiSCSISetup.sh [–f <parameter name> [-n]]
 When you specify -f <parameter name>, a parameter is loaded from the file specified.
 When you specify -n, a dry run is performed to check for any parameter error, and does not
process
The details of the parameter file are described as follows.
Details
-m <Serial number>
-I <Password of CHAP initiator>
-t <Password of CHAP target>
-p <IP address of host connection port>
Release 6.0
Appendix F How to Set/Check Application Server (Linux) (iSCSI)
394