NEC Storage M100 Series User Manual page 287

User Guide
Problem
When a serial number is entered, the
message, "The target has already
been assigned to the initiator. Serial
number =" is displayed.
When a serial number is entered, the
message, "Failed to collect the disk
array information. (Error code:xxxx)"
is displayed.
When you click Logon, the message,
"Please enter a target secret." is
displayed.
When you click Logon, the message,
"Target secret unmatch. Please enter
the target secret again." is displayed.
When you click Logon, the message,
"Please enter a CHAP secret." is
displayed.
When you click Logon, the message,
"CHAP secret unmatch. Please enter
the CHAP secret again." is displayed.
When you click Logon, the message,
"Logon Failed.(Error code." is
displayed.
Release 6.0
Cause and Solution
The target with the initiator already exists.
To register the initiator again, delete the LD set to which the
initiator was added by using the LD Set management of the
iSM client, and then run the iSCSI Setup Tool again.
An error occurred in retrieving the disk array information.
For details, see Section 10.4.3: "iSCSI Setup Tool Error
Codes".
The CHAP authentication check box is selected but
information for Target secret and Target secret again is not
entered.
Enter information in the Target secret and the Target secret
again boxes.
The information entered in the Target secret does not
match with that of the Target secret again.
Re-enter information in the Target secret and the Target
secret again boxes.
The Mutual CHAP authentication check box is selected but
information for the CHAP secret and CHAP secret again is
not entered.
Enter information in the CHAP secret and the CHAP secret
again boxes.
The information entered in the CHAP secret does not match
with that of the CHAP secret again.
Re-enter information in the CHAP secret and the CHAP
secret again boxes.
An error occurred in logging on to the target.
For details, see Section 10.4.3: "iSCSI Setup Tool Error
Codes".
287
Chapter 10 Troubleshooting