RED epic Operation Manual page 99

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
6. Start recording.
The overlay displays the number of frames recorded out of the total amount of frames.
NOTE: There may be a delay between receiving the external trigger and capturing the next frame(s). The delay
may be as long one (1) frame period at the current recording frame rate. To completely synchronize frames to
an external trigger, set Sensor Sync Mode to MoCo. For more information, go to
SPEED RAMP MODE
NOTE: This mode is not available in Stills mode.
Speed Ramp mode lets you program the current recording frame rate to transition to different recording frame
rates during recording.
1. Go to Menu > Settings > Recording > Mode.
2. Select Speed Ramp Mode from the Mode drop-down menu.
3. Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).
4. Select a ramp target:
Ramp A/B/C/D: Each ramp target is tied to a specific Target/Duration combination.
‒
Ramp Reset: Ramp to the starting frame rate with the specified Duration.
‒
5. Set the Target frame rate.
6. Set the Duration, which is how long it takes to transition from the current frame rate to the target frame rate.
7. Go to Menu > Settings > Setup > Keys and program a key to start the speed ramp:
‒ Record: Start Speed Ramp A/B/C/D
‒ Record: Start Speed Ramp Reset
8. Start recording.
9. To start speed ramp, press the key that you have mapped to start the speed ramp.
The frame rate transitions to the target frame rate during the duration you set up.
NOTE: If using speed ramp mode, select an exposure that is valid for each ramp target frame rate. If the camera
ramps to a frame rate that is incompatible with the current exposure, the exposure changes to the longest
exposure possible for the frame rate.
REDCODE BURST
NOTE: This mode is not available in Stills mode.
In REDCODE Burst mode, the camera can record at a lower compression (REDCODE) for the specified amount
of frames.
When REDCODE Burst mode is enabled and recording starts, the camera captures a "burst" of frames at the
lower REDCODE, and then continues to record at the next available REDCODE. To add more bursts to clips
during recording, press any key mapped to "Record: Mark Frame".
To use REDCODE Burst mode, follow the instructions below:
1. Go to Menu > Settings > Recording > Mode.
2. Select REDCODE Burst from the Mode drop-down menu.
3. Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).
4. Select a Pre Count and Post Count. For more information, go to
5. Close the menu.
6. Start recording.
COPYRIGHT © 2015 RED.COM, INC
"Sync" on page
"Pre Count and Post Count" on page 100
955-0020_V6.0, REV-J |
106.
99