RED epic Operation Manual page 42

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
REPLACE THE HOOD SCOOP
REQUIRED TOOL: T8 TORX driver
The hood scoop on some EPIC-X and EPIC-M models extends beyond the rear plane of the BRAIN. RED offers
shorter hood scoops so that you can attach an LCD or other accessory to the mounting locations on the top
of the +1 Adaptor Module.
To replace DSMC fan hood scoop, follow the instructions below:
1. Turn off the BRAIN.
2. Remove the four (4) M3x0.5 x 6 mm screws holding the hood scoop using a T8 TORX driver.
3. Remove the hood scoop.
4. Position the replacement hood scoop on the BRAIN.
5. Align the hood scoop screw holes with the threaded holes.
6. Insert and tighten the four (4) M3x0.5 x 6 mm screws in a cross pattern ("X" pattern) using a T8 TORX driver.
DO NOT FULLY TIGHTEN.
7. Fully tighten the four (4) M3x0.5 x 6 mm cap screws evenly in a cross pattern ("X" pattern). DO NOT exceed
30 in-oz, or damage may occur.
WARNING: DO NOT OVERTIGHTEN.
COPYRIGHT © 2015 RED.COM, INC
Replace the hood
scoop
955-0020_V6.0, REV-J | 42