RED epic Operation Manual page 158

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
SET UP INTERNAL TIMECODE
To set up and adjust timecode generated by the camera, follow the instructions below:
1. Go to Menu > Settings > Project > Timecode.
2. Select the desired Timecode Display mode.
3. Set Source to User Provided.
4. Select the LTC Out check box to perform Linear Timecode Out, if applicable.
5. Use the additional controls to sync TOD timecode with the RTC or set manually.
Alternatively, go to Menu > Media > Device > Format Media... to set Edge timecode manually.
The TC indicator in the Lower Status Row remains grey when internal timecode is enabled.
INPUT EXTERNAL TIMECODE
To set up and adjust timecode generated by an external device, follow the instructions below.
1. Connect the external timecode generator to the camera using a 3BNC-to-00 LEMO
A. Connect the yellow BNC connector to the output on the timecode generator.
B. Connect the 00B LEMO connector to the SYNC port on the BRAIN.
2. Go to Menu > Settings > Project > Timecode.
3. Select the desired Timecode Display Mode.
COPYRIGHT © 2015 RED.COM, INC
Source: User Provided
Sync Cable.
®
955-0020_V6.0, REV-J | 158