RED epic Operation Manual page 38

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
INSTALL THE MODULE ADAPTOR
You must install an adaptor module on the back of the BRAIN before you install a DSMC module.
REQUIRED TOOL: T20 TORX driver
1. Turn off the BRAIN.
2. Remove the REDMOTE, if attached.
3. Position the Module Adaptor over the V-mount on the rear of the BRAIN.
4. Apply pressure and tighten the four (4) captive screws in a cross pattern ("X" pattern) approximately two (2)
turns each using a T20 TORX driver. DO NOT FULLY TIGHTEN.
5. Fully tighten the four (4) screws in a cross pattern ("X" pattern) using a T20 TORX driver.
WARNING: DO NOT OVERTIGHTEN.
COPYRIGHT © 2015 RED.COM, INC
Install Module Adaptor
Tighten screws
955-0020_V6.0, REV-J | 38