RED epic Operation Manual page 54

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
APERTURE
The aperture (also known as the T stop or F stop) parameter displays when a compatible mount and lens are
installed. The aperture controls the depth of field of the image and, in combination with the shutter speed/angle
setting, controls the amount of light that reaches the sensor (exposure).
 Increasing the aperture to a higher number increases the depth of field, but reduces the exposure (brightness).
 Decreasing the aperture to a lower number decreases the depth of field, but increases the exposure
(brightness).
RED DSMC PL MOUNT INSTALLED
The current aperture of the attached lens displays when a DSMC PL mount is installed and a supported lens
®
equipped with Cooke S4/i system is attached.
® ®
DSMC NIKON MOUNT AND CANON MOUNT INSTALLED
The Aperture menu is visible when a DSMC Nikon Mount, DSMC Canon Mount, or DSMC RED MOTION MOUNT
® ® ®
Ti Canon is installed and a supported lens is attached. This enables you to adjust the aperture of the attached
lens.
Select the Advanced... button to access the Menu > Settings > Setup > Lens screen. For more information, go to
"Autofocus Modes (DSMC, Nikon, and Canon Mounts)" on page 131.
REDCODE
Select the target REDCODE compression ratio for your project.
If the camera is able to achieve the target compression ratio, the compression ratio displays in white. If the
camera is unable to achieve the target compression ratio, the compression ratio displays in yellow.
The current compression ratio is automatically recalculated when changes are made to the project resolution,
aspect ratio, anamorphic setting, frame rate, HDRx mode, media, or the target REDCODE compression ratio.
 MYSTERIUM-X: Range is 3:1 to 18:1. Default is 8:1.
 RED DRAGON: Range is 2:1 to 22:1. Default is 8:1.
For maximum available REDCODE values, see the DSMC Media Operation Guide at www.red.com/downloads.
COPYRIGHT © 2015 RED.COM, INC 955-0020_V6.0, REV-J | 54