RED epic Operation Manual page 105

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
CAMERA NAME
Use the Camera menu to set up a unique identifier for your camera (or a group of cameras). All command
filtering happens on the receiver side of the communication link. Use camera names and group names to
address commands to a specific camera or group of networked cameras.
 Camera ID: Enter a unique camera name to use in network communications. The field is limited to eight (8)
characters.
 Group ID: Enter a group name to identify the camera as a member of a group of devices. The field is limited
to eight (8) characters, and the default name is DEFAULT.
 Target: Specify which devices the camera can send commands to:
‒ All: The camera can send commands to all devices on the network.
‒ None: The camera can only receive commands. The camera cannot send commands.
Custom: The camera can send commands to a specific camera/device (enter the name of the camera/
‒
device in the Target ID text box) or a specific group (enter the name of the group in the Target ID text
box). The camera/group name must match the name entered in the Name/Group field of the target
device(s).
SERIAL PROTOCOL
The camera can communicate to external devices via the CTRL and the GIG-E connectors (camera-to-camera
communication is possible only via GIG-E or the REDLINK
Select one of the following protocols from the Serial Protocol drop-down menu:
 None (Default)
 Element Technica
 3ality SPC 7XXX
 REDLINK Command Protocol
COPYRIGHT © 2015 RED.COM, INC
Bridge).
®
955-0020_V6.0, REV-J | 105