RED epic Operation Manual page 46

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
14. Replace and loosely tighten the four (4) M4x0.7 x 8 mm lens mount screws in a cross pattern ("X" pattern)
using a T20 TORX driver. DO NOT FULLY TIGHTEN.
NOTE: The DSMC Mg PL Mount 2.0 has captive screws that are not removable from the mount.
15. Fully tighten the four (4) lens mount screws in a cross pattern ("X" pattern) using a T20 TORX driver. DO
NOT exceed 350 in-oz, or damage may occur.
NOTE: DO NOT OVERTIGHTEN.
16. Turn on the BRAIN.
17. Go to Menu > Settings > Maintenance > OLPF.
18. Select the installed OLPF from the Type drop-down menu.
IMPORTANT: Ensure the correct OLPF type is selected from the drop-down menu. Failure to select the
correct OLPF type will affect color accuracy. For more information, go to
COPYRIGHT © 2015 RED.COM, INC
Replace Lens Mount
"OLPF" on page 121.
OLPF Type menu
selection
955-0020_V6.0, REV-J | 46