RED epic Operation Manual page 40

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
4. Insert the HDMI connector into the HDMI port on the BRAIN.
5. Apply pressure and tighten the four (4) captive screws in a cross pattern ("X" pattern) approximately two (2)
turns each using a T20 TORX driver. DO NOT FULLY TIGHTEN.
6. Fully tighten the four (4) screws in a cross pattern ("X" pattern) using a T20 TORX driver.
WARNING: DO NOT OVERTIGHTEN.
REMOVE THE +1 ADAPTOR MODULE
REQUIRED TOOL: T20 TORX driver
1. Turn off the BRAIN.
2. Loosen the four (4) captive mounting screws in a cross pattern ("X" pattern) using a a T20 TORX driver.
3. Disconnect the HDMI connector from the BRAIN.
4. Remove the +1 Adaptor Module from the BRAIN.
COPYRIGHT © 2015 RED.COM, INC
Insert the HDMI
connector to the
BRAIN
Tighten screws
955-0020_V6.0, REV-J | 40