Use A Tripod Or Monopod - RED epic Operation Manual

R E D D S M C O P E R AT I O N G U I D E : E P I C / S C A R L E T
VERIFY INSTALLED OLPF
You can see which DSMC Interchangeable OLPF is installed even when a DSMC lens mount is attached. The
OLPF type is labeled in two (2) locations on each DSMC Interchangeable OLPF.
# LOCATION ON ASSEMBLY
1 Top inside
2 Front bottom

USE A TRIPOD OR MONOPOD

This section describes the DSMC mounting points and mounting equipment for use with a tripod or monopod.
The DSMC is equipped with two (2) 3/8-16 mounting holes and one (1) 1/4-20 mounting hole on the bottom
of the BRAIN. These mounting points are designed for use with a variety of mounting plates and hardware, to
support tripods and other support systems.
WARNING: Ensure that the tripod, monopod, or support system is designed and rated to handle the weight of
your DSMC configuration. RED is not responsible for any damage caused by using a tripod, monopod, mount,
or support system that does not provide sufficient support.
WARNING: DO NOT use excessive force to mount a support accessory, as this may damage the screw threading.
RED offers the following products for use with tripods and other support systems:
ITEM
Mounting Plate (DSMC)
DSMC Modular Assault Plate Pack
DSMC Quick Release Platform Pack
Quick Release Platform Pack (Bolt-On)
Quick Release Platform (Dovetail)
Quick Release Platform (Mini)
Dovetail Mounting Plate (Long)
Dovetail Mounting Plate (Short)
For more information, visit the
COPYRIGHT © 2015 RED.COM, INC
LABEL
Identifier symbol, such as (S)
OLPF type
RED store at www.red.com/store.
1
2
VISIBLE WITH
DSMC PL mounts
All DSMC mounts
PART NUMBER
790-0094
790-0224
790-0183
790-0078
790-0079
790-0390
790-0083
790-0084
OLPF Type Labels
955-0020_V6.0, REV-J | 47