Table of Contents
Advertisement
7.5.1
Operation keys
7.5.1.1
PRE TALK SRC (Pre Talk Source)
With the help of the PRE TALK SRC button it can be selected whether the Pre
Talk should be done via the optional handset (
Audio input which is configured as Pre Talk (
CHAPTER 7.7.3.14, page 98).
The switch over of the Pre Talk Source can also be automated. In this case for
example, the presenter must always use the Audio input and the Pre Talk
source must always use the Handset (configuration in the LAN
→
tions
Pre Talk Source Auto Following submenu (see CHAPTER 7.7.3.13,
page 95))
The Pre Talk mode is automatically signalled by the Pre Talk Relay (see
CHAPTER A4.5, page 146).
If the presenter switches the caller into Pre Talk the Pre Talk Relay can be
used to switch in a mixer automatically. If the Pre Talk Source is automated
(see previous info box) the Pre Talk Relay will also switch in the mixer only
if the pre talk source is in pre talk with the caller. In the General
relay submenu choose the Pre Talk Signalling combined with Pre Talk
Source option to switch in the mixer only if the presenter is in pre talk via the
Audio input. Do not forget to set in the Relay submenu (see CHAPTER
7.7.3.15, page 102) the Audio Line
relay to ensure that a Pre Talk relay exists.
7.5.1.2
GLOBAL (Drop All, Lock)
With the help of the
tions are dropped. Not included in this function are lines defined as VIP lines
(see CHAPTER 7.7.3.5, page 76).
If the
tem are blocked for incoming calls. Lines defined as VIP lines are excepted
(see CHAPTER 7.7.3.5, page 76)
If the lock button is active, the callers hear the busy signal. This function de-
pends on the PABX. Main connections always support this function.
7.5.1.3
Forw. Call (Call forwarding)
The
Redaktion
call forwarding destinations. The second call forwarding destination is only
for temporary use. This means that after forwarding the first call the call for-
warding destination is set again.
The call forwarding destinations are defined in the submenu S
Forwarding
number for Call Forwarding (see CHAPTER 7.7.3.4, page 73). The corre-
sponding Name of the call forwarding is displayed on the operating key.
M A G I C
→
PRE TALK assignment for at least one
(drop all connections) operating key all connec-
(Lock) button is active (
.
Outgoing calls are possible on any line.
Call Forwarding button enables the selection of two predefined
→
1st. telephone number for Call Forwarding and 2nd. telephone
T O U C H
S o f t w a r e
key setting) or via the
key setting) (see
→
Restric-
→
Pre Talk
key setting), all lines of the sys-
→
Line
0
P A G E 4 5
Call
Advertisement
Table of Contents
