Relays (Relays Settings) - AVT Magic Touch Operating Manual

M A G I C T O U C H S o f t w a r e
P A G E 1 0 2
7.7.3.15

Relays (Relays settings)

The configuration of the three relays on each system (see CHAPTER A4.5,
page 146) is done via the Relay link.
FIG. 68
After pressing the OK button, all settings are accepted.
The Cancel key deletes the settings.
Depending on the number of systems available, three relays Relay 1 ... Relay
3 are displayed for each system. The following settings are possible for these
relays:
– Fixed: The relay is fixed. After turning the system on the relay can always
be closed (always closed) or can always be open (always open).
– Incoming call (PC controlled): To suppress a signalling for blocked callers,
the telephone number is first transmitted to the PC. If the caller is not
blocked the relay will be closed. Otherwise there will be no signalling.
Normally define this setting for call signalling.
– Incoming call: If there is an incoming call on any channel the relay will be
closed.
In this operating mode if there is no check of the telephone number, the relay
signals an incoming call even if the caller is blocked.
CONFIGURATION OF THE RELAYS