Table of Contents
Advertisement
3
P U T T I N G T H E S Y S T E M I N T O O P E R A T I O N
3.1
Mounting
With its dimensions (W × H × D) of 220 mm × 44,5 mm (1 U) × 220 mm the
MAGIC TH1Go system can be either used as desktop device or mounted in a
19 inch rack. Corresponding 19" mounting brackets are included in delivery.
When mounting the unit please keep in mind that the bending radius of the
cables is always greater than the minimum allowed value.
When the MAGIC TH1Go Telephone Hybrid is installed, please make sure
that there is sufficient air ventilation: It is recommended to keep a spacing of
ca. 3 cm from the openings. In general, the ambient temperature of the system
should be within the range of +5 ° C and +45 ° C. These limits are especially to
observe if the system is inserted in a rack. The systems works without venti-
lation.
TIP
The system temperature can be indicated on the display (
mation
)
During operation air humidity must range between 5 % and 85 %.
ATTENTION Incorrect ambient temperature and humidity can cause functional defi-
ciencies.
Operation outside the threshold values indicated above leads to a loss of war-
!
ranty claim.
3.2
Connection to the mains voltage
The system can be operated with mains voltage in the range of 90 V and 253 V
via the external power supply adapter included in delivery. The mains fre-
quency can range from 45 Hz to 65 Hz. The maximum power consumption is
15 W. The rack must be earthed according to the VDE Regulations. This can
be carried out via the earthing screw on the back side of the unit.
After plugging in the external power supply adapter the unit boots in a few
seconds. In standby mode the level meter/status display is shown on the dis-
play.
P u t t i n g
t h e
s y s t e m
i n t o
o p e r a t i o n
Menu Status Infor-
P A G E 1 7
Advertisement
Table of Contents
