Table of Contents
Advertisement
7.5.2
No
Predefined
Connection
call
7.5.2.1
7.5.2.2
Line functions
The following figure shows the possible line modes:
FIG. 26
LINE FUNCTIONS AND MODE DISPLAY
Incoming call
Caller in
(blinking)
Pre Talk
Depending on the usage of the MAGIC TOUCH LAN or MAGIC SCREENER
software options, single lines can be highlighted in grey. Then the MAGIC
TOUCH user has no further access anymore to this line. Transfer point is al-
ways the Hold mode. It sets a line free.
Line functions without existing connection
If there is no connection the following functions are available:
– By pressing the
(Pre Talk), the
ton, either the manual call dialog or the telephone book opens depending
on the configuration. The configuration of this optional function is done
→
via General
Miscellaneous Settings
(see CHAPTER 7.7.3.1, page 58).
– With the help of the
for a call (see Fig. 25, page 50)
Line functions with existing connection or incoming call
If there is an existing connection or an incoming call the following functions
are available:
– The
(Pre Talk) key switches the caller in pre talk
available if a Pre Talk Audio interface was defined in Audio Lines (see
CHAPTER 7.7.3.14, page 98).
– The
(Hold) key puts the caller in the hold position
hears the selected signal, defined in Hold Signal Recording/Source
→
eral Settings
Hold Signal Source (see CHAPTER 7.7.3.10, page 87).
M A G I C
T O U C H
Caller in Hold
Caller
position
On Air
(Hold) or the
→
Show dial dialog on disconnect
information button, a line can be predefined
. This key is only
S o f t w a r e
Caller being for-
warded
(On Air) but-
. Now the caller
→
Gen-
P A G E 5 1
Advertisement
Table of Contents
