Table of Contents
Advertisement
7.7.3.10
Hold Signal Recording/Source
The Hold interfaces of the system are configured via the link Hold Signal Re-
cording/Source. An extended possibility is to store a Hold signal of 8 seconds
duration in the system.
FIG. 57
After pressing the OK button, all settings are accepted.
The Cancel key deletes all settings.
7.7.3.10.1
General Settings
With the help of the General Settings
desired Hold signal source. Two options are possible:
– On Air: the caller hears the programme in the Hold mode. This setting is
only available if the On Air Audio interface (see CHAPTER 7.7.3.14,
page 98) was configured.
– Hold: in the Hold mode the caller hears the signal fed to the Hold interface.
This setting is only available, if the Hold Audio interface (see CHAPTER
7.7.3.14, page 98) was configured.
– Recorded Hold Signal: the caller hears the Audio signal of max. 8 seconds,
stored in the system (see CHAPTER 7.7.3.10.2, page 88).
– Dynamic Hold: the caller hears the Audio signal that is assigned to the line.
This signal is either the On Air signal or an input signal of the Alternative
On Air Line 1...4 (see CHAPTER 7.7.3.1.2, page 60). This setting is only
available if at least one Alternative On Air Audio interface (see CHAPTER
7.7.3.14, page 98) was configured.
The setting Pause between repetition is only relevant for the setting Recorded
M A G I C
HOLD SIGNAL RECORDING/SOURCE
→
Hold Signal Source submenu, set the
T O U C H
S o f t w a r e
P A G E 8 7
Advertisement
Table of Contents
