Table of Contents
Advertisement
7.7.3.2
Slave Search
If several systems are connected to each other via the Extension Bus, these sys-
tems must be installed by the software when operating for the first time. This
is done via the link Slave Search.
Press the Auto detect button to start the search. After a couple of seconds all
slave systems (maximum three) should be listed. The Master system is not
displayed. The displayed address is only relevant for internal use.
If one system is lacking, even though it has been connected and turned on,
check if all Dongles have been properly connected (see Fig. 11 and Fig. 12)
FIG. 44
After pressing the OK button all settings are accepted.
The Cancel key deletes the settings.
M A G I C
SEARCH OF THE SYSTEMS ON THE BUS
T O U C H
S o f t w a r e
P A G E 6 9
Advertisement
Table of Contents
