Table of Contents
Advertisement
M A G I C
T O U C H
S o f t w a r e
P A G E 8 8
Hold Signal. Enter the length of the pause in seconds which will be inserted
when playing the stored Hold signal again.
The duration of the stored Hold signal is displayed in Hold Signal duration.
The value can not be changed.
7.7.3.10.2
Hold Signal Recording
The recording of a Hold signal is done via Hold Signal Recording.
First, choose the Record source where the Hold signal will be recorded. The
following interfaces can be selected:
– Master: Analogue Audio
– Master: AES/EBU/ANALOGUE Module Left (only if the optional module
is installed)
– Master: AES/EBU/ANALOGUE Module Right (only if the optional mod-
ule is installed)
Press Start to start the recording. The moving bar displays how much space
has already been used from the storage space of 8 seconds.
The recording is interrupted via Stop.
By pressing the Save button, the recording is stored in the system.
Please note, that the recorded Hold-signal will be deleted in the system when
doing an update of the firmware.
Record the Hold signal again after each unit update.
7.7.3.10.3
Test Recorded HOLD Signal on Master Analogue output
The stored signal can be checked via the analogue output of the Master sys-
tem at any time, although so far it was not stored via Save.
The Start button starts playing the recording.
Press Stop to finish the tapping of the recording.
Advertisement
Table of Contents
