Utility-T1 Line Trace (Kx-Tda100/Kx-Tda200/Kx-Tda600 Only); Utility-Isdn/Qsig Protocol Trace - Panasonic KX-TDA50 Programming Manual

4.
Click Start.
Monitoring will be performed and the screen will refresh according to the interval specified.
5.
Click Stop to end monitoring.
To refresh the screen at any time while monitoring is stopped, click Refresh.
2.5.10 Utility—T1 Line Trace (KX-TDA100/KX-TDA200/KX-TDA600
only)
Traces the sent and received signaling bits and dial numbers on the specified channel of the T1 line.
This utility is intended for use by dealers.
This option is only available at Installer level, and requires that the target T1 card be set to INS status.
To view T1 trace data
1.
From the Utility menu, select T1 Line Trace.
2.
From the Slot No drop-down list, select the target slot.
3.
From the CH No drop-down list, select the target channel.
4.
Click Start.
Trace information will be displayed. The information is automatically updated whenever the data
being monitored changes.
5.
Click Stop to end the trace.
6.
Select an option:
• Click Capture to save the displayed trace information.
Information is saved as a text-format file.
• Click Clear to erase the information.
2.5.11 Utility—ISDN/QSIG Protocol Trace
This utility collects protocol trace data from PRI or IP-GW cards, and displays it on the PC.
This option is only available at Installer level, and requires that the target PRI or IP-GW card be set
to INS status.
Protocol trace data is continually accumulated on ISDN and IP-GW cards, and 3 types of data can be
downloaded:
• Real Time Trace (not available when connecting via LAN): Pseudo-real-time data is collected
through data polling at one-second intervals. The displayed information is updated beginning
when the Start button is clicked.
• Accumulation Trace: Previously accumulated data is retrieved and displayed.
• Error Accumulation Trace: Previously accumulated error data is retrieved and displayed. This
trace shows the data snapshot that is taken just before a card resets.
To view trace data
1.
From the Utility menu, select ISDN/QSIG Protocol Trace.
2.
From the Slot No drop-down list, select the target slot.
3.
From the Trace Data Type drop-down list, select the type of data to view.
4.
Click Start.
2.5 Utility
PC Programming Manual 61