Panasonic KX-TDA50 Programming Manual page 147

Networking Data Transfer
Enables transmission of extension status data to connected PBXs in a network. This setting is only
available when Port Type on this screen has been set to QSIG-Slave or QSIG-Master.
Default
No
Value Range
No, Yes
Maintenance Console Location
2.7.14 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
2.15 [9] Private Network
Feature Manual References
1.13.15 Private Network Features—NDSS (Network Direct Station Selection)
Loopback Test started by Network (MPR Software File Version 3.2000 or
later)
Enables a loopback test started from the network side, to be performed on the PRI23 card.
Note
The version of the PRI23 card must be 2.000 or later.
Default
Disable
Value Range
Disable, Enable
Maintenance Console Location
2.7.14 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
Network Loopback Test (KX-TDA100/KX-TDA200/KX-TDA600 only) (MPR Software File Version
3.2000 or later)
Feature Manual References
None
Extension Setting
Extension Setting parameters are applicable only for the PRI extension port.
2.7 [1] Configuration
PC Programming Manual 147