Access Levels - Panasonic KX-TDA50 Programming Manual

2.1 Introduction
Connection Settings for LAN
Setting
IP Address
Port Number
2.1.2

Access Levels

There are three main levels of access to the Maintenance Console: User, Administrator and Installer.
Each level has its own Programmer Code, which must be entered to run the Maintenance Console.
The allowed format for each programmer code is as follows:
User Level Programmer Code
Administrator Level Programmer Code
Installer Level Programmer Code
Access to menu options within the Maintenance Console is restricted depending on the Programmer
Code, and the current software mode (see 2.1.1 Starting Maintenance Console and Software
Modes). When a menu option is limited to certain access levels, this is noted in this manual in the
initial description of that menu option, for example:
"This option is only available at Installer level."
If a sentence like this does not appear under the heading, the menu option is available at all levels.
The target users for each access level are as follows:
Access Level
User
Administrator
Installer
The options available in each mode and access level are shown below.
The access levels are abbreviated as follows:
U: User; A: Administrator; I: Installer
A check mark indicates that the menu option is available for that access level.
20 PC Programming Manual
Values
1.0.0.0–
223.255.255.255
10000–65535
Item
User
For end users
For system administrators
For dealers and system installers
Explanation
Specify the IP address of the PBX on the LAN.
Enter the same IP address that was input in IP
Address of 2.7.28 [1-1] Slot—CTI-LINK Card
Property (KX-TDA100/KX-TDA200/KX-
TDA600 only).
Specify the port number used to access the
PBX via LAN. Enter the same port number that
was input in Maintenance Port Number of
2.7.28 [1-1] Slot—CTI-LINK Card Property
(KX-TDA100/KX-TDA200/KX-TDA600 only)
or 2.7.19 [1-1] Slot—IP-GW Card Property
(KX-TDA50 only).
Length
0 – 16 characters
4 – 16 characters
4 – 16 characters