Micros Systems Workstation 5 Service Manual page 73

Five Beeps - CF Not Found
Incorrect CMOS Configuration or corrupt CMOS memory. Make
o
sure a CF card is installed if this is a WINCE unit. See below to
Reset CMOS Defaults.
Check the Daughter Card CF socket for bent pins and make sure the
o
CF Daughter Card is seated properly in the system board connector,
IDE1.
Defective or incompatible CF Card.
o
Defective System Board.
o
Six Beeps - USB Flash Drive Not Found
Make sure the USB flash drive is correctly oriented on the 2x5
o
socket, J9. See 4-19.
Defective USB Flash Drive.
o
Defective System Board.
o
Incorrect CMOS Configuration or corrupt CMOS - See below to
o
Reset CMOS Defaults.
• If NO, the boot process halts and a text message reports "UDOC.ID not
found," "Operating System Not Found," or "Remove disks or other media.
Press any key when ready," or similar.
Remove the USB 'Stick,' 'Thumb' or Flash Drive from the IO panel
o
USB connector or refer to the Figure below and attach it to the
connector shown in brackets []. Connecting a USB thumb drive to the
port indicated prevents start-up errors in situations where the device
must remain attached across reboots.
Figure 3-2: Recommended USB Port for e7 Installations and Upgrades
Workstation 5 Field Service Guide
Workstation 5 Troubleshooting
Operational Troubleshooting
3-5