C - Cutter Parameters - CAB A+ Series Programming Manual

214

C - Cutter Parameters

The C command is used to set the parameters for the optional cutter or perforation cutter. The cutting
command uses the label counter to cut after a specified amount of printed labels or can be set to cut at
the job end. Additonally it is possible to perform a second cut (double-cut) in one label.
Furthermore an optional perforation cutter is available, which can perforate and which is also able to
do a "regular" cut.
Syntax:
Please see also the "O" command to adjust the cutting time ( cutting depth ) for the perforation
cutter. All measurements in millimeters or in inches (see the „m" command)
cab Produkttechnik GmbH & Co KG
C x[,disp1[,disp2]] CR
C - cutting command
x = cutting method - valid parameters are:
amount =
e
s
p
sp =
disp1 = (displacement 1) - offset to the end of the defined label
disp2 = (displacement 2) - offset to the first cutting position.
(always positive values !)This double cut option offers the possibility
to cut off portions of a label. [disp2] is not available when the „cut
before first label ( s) parameter is used. disp2 is only available for
regular cuts and not for perforations !
amount of labels after which a cut is processed.
Possible values 1-9999
= cutting at the job end.
Cuts once at the job end which is defined by the "A"
(amount) command.
= cut at print start (before the first label. This command is
only executed once in the job and can be combined
with " C amount ". disp1 is an optional offset in the
chosen unit.
= perforate - requires the optional perforation cutter !
perforate at the start of the printjob ( requires the
optional perforation cutter !, and can be combined
with " C amount ". disp1 is an optional offset in the
chosen unit.
Optional cutter required
214
214