Machine Parameters - CAB EOS1 Configuration Manual

12 4 Configuration
4.1.2

Machine Parameters

 Start Offline menu.
 Select Setup > Machine param..
Parameter
Printhead pos. X
Printhead pos. Y
Tear-off pos.
Cutter
> Cut position
> Cutting depth
Backfeed
position
Brightn. LCD
Contrast LCD
Volume Speaker
Time Powersave
Cleaning
interval
Debug mode
Table 3
Meaning
Shifting of the entire print image perpendicular to the direction of
paper flow.
The absolute shifting is limited by the margins of the print zone.
Those are determined by the width of the printing line on the
printhead. The Printhead pos. X can also be set via software.
The offset values from the Machine param. menu and the
software are added together.
Shifting of the entire print image in the direction of paper flow. With
positive values, printing begins later in the direction of paper flow.
Shifting of the print image in the direction of paper flow also influ-
ences the cut position.
 Correct the Cut position parameters by the same value in the
opposite direction.
The Printhead pos. Y can also be set via software. The offset
values from the Machine param. menu and the software are
added together.
Shifting of the tear-off position in the direction of paper flow. With
positive values, the label strip is transported farther out of the printer.
Configuration of the cut parameters for devices with cutter.
If cutter is not installed, access only with service key inserted
Offset of the cut position relative to the rear label edge.
The Cut position can also be set via software. The offset values
from the Machine param. menu and the software are added
together.
with perforation cutter only
Setting of the perforation depth.
The Cutting depth can also be set via software. The offset values
from the Machine param. menu and the software are added
together.
Offset of the backfeed movement
Brightness of the LCD display from 1 to 8.
Contrast of the LCD display from 0 to 15.
Volume of the speaker : Mute, 1 or 2.
Time between the last operation and activation of energy-saving
mode.
Setting of intervals for printhead cleaning in increments of 100 m
media passage.
If the set length of the medium (label strip, transfer ribbon) has
passed the printhead and an error occurs in the flow of the medium
(e.g. label end, transfer ribbon end), the Clean printhead!
message appears in the display.
The error message for the error which occurred is not displayed until
the Clean printhead! message is acknowledged. As long as no
errors occur in the medium flow, no messages are displayed and the
print job is continued even if the cleaning interval has passed.
Operating mode which supports the firmware programmer when
localizing errors.
Parameters of the menu Setup > Machine param.
12
Default
0,0 mm
0,0 mm
0,0 mm
0,0 mm
0
0,0 mm
8
6
1
5 min
1000 m
Off