20
6
Cleaning
6.5
Cleaning the Cutter
Attention!
!
When cutting through the label material remains of adhesive may accumulate on the blades. If operating in
backfeed mode, such remains of adhesive may be deposited on the drive roller as well.
Both, the drive roller and the cutter blades, must be cleaned often.
1
Fig. 10
Cleaning the cutter
1. Turn the control panel (1) down.
2. Unlock the cutting unit (3) at the both plastic latches (2) and lift it.
3. Turn the screw (4) clockwise using a 2.5mm Allen key and that way swivel the clamp (6) with the lower blade (7)
away from the upper blade (5).
Warning!
!
Risk of cuts and bruisings!
Do not touch the blade edges with bare hands.
Keep the hands away from the swivel range of the lower blade.
4. Remove particles of dust and paper with a soft brush or a vacuum.
5. Remove remains of adhesive with isopropyl alcohol.
6. Remount in reverse order.
2
3
4
5
6
20
7