Changing The Drive Of The Cutter - CAB MACH 4.3S/200B Service Manual

2 Changing Assembly Parts
2.9

Changing the Drive of the Cutter

2
1
Fig. 9 Changing the drive of the cutter
1. Fold down the control panel (1), release the cutter (4) from the brackets (3) and fold this up too.
2. Unhook the springs (3).
3. Disconnect the plug (7).
4. Undo and remove the nuts (11), screws (9) with connecting rods and bearings.
5. Unlock the eccentric (10) from the shaft (6).
6. Lift out shaft (6) with the drive (8) from the base plate (12).
7. Pull the drive (8) from shaft (6).
8. To reconstruct the assembly follow these instructions in the reverse order. Place the drive into the adjustment slot
of the base plate (10).
!
Attention!
 Align the pins of the eccentric (10) to the clock wheel (5) as illustrated.
3
2 3 4
9 10 11
5 6 7
12 10 9
8
15