F - Formfeed - CAB A+ Series Programming Manual

73

f - formfeed

This command feeds the media forward until the top-of-form of the next label reaches the printhead. It
does the same as pressing the feed button on the printer´s control panel.
This process is controlled by the label photocell if die cut label material is used. The printer feeds the
material in continuous form mode in the length which had been selected for the last printed label.
The label photocell is disabled for gap detection and controls only if paper is out.
In continuous form mode the printer counts the steps of the stepper motor to reach the expected print
length.
Syntax:
Example:
cab Produkttechnik GmbH & Co KG
f CR
f CR
f CR
feeds 2 empty labels.
73
73