99
B - Barcode Definition - options overview
Example:
Example:
cab Produkttechnik GmbH & Co KG
+GOODBADn = Same function as +VERIFYn without checking the content. Only
good read or bad read will be controlled. Checks the answer on
NoReadString „?" „n" is the starting value in millimeters or
inches, whatever is set up in your label.
m m
J
S l1;0,0,68,70,100
O R
B 5,12,0,CODE39+GOODBAD0,5,.5,4;1234567890
A 1
In this example, the scanner starts at 5 mm from top of the
barcode with scanning and verifies only if the barcode is
readable or not ( GOOD or BAD)
NO content check will be done in this case.
,GOODBADn = Controls the readability of barcodes which have been
transmitted as graphics (i.e. by some labelling programs).
Controls only good read or bad read. „n" is the starting
value in millimeters or inches, whatever is set up in your label.
m m
J
S l1;0,0,68,70,100
O R
I 10,10,0,1,1,GOODBAD0;PICT1
A 1
In this example, the scanner reads the previously downloaded
graphical barcode and does a good read or bad read check.
+VERIFYn, +GOODBADn and ,GOODBADn are available for all
barcodes, this will not be mentioned explicit in the decription of
each single barcode on the following pages.
+CCn
= defines the height of a composite line in module width.
Default value is 2 and the maximum value is 99.
continued on the next page
99
99