J - Job Start - CAB A+ Series Programming Manual

242

J - Job Start

The J command „tells „ the printer, that the following data contains label specific data. It starts a new
print job.
Syntax:
Example:
cab Produkttechnik GmbH & Co KG
J [comment] CR
J - Job start command.
comment = Optional text which may describe the label.
J Adress Label
Defines the job start and names the label „ Adress Label".
Adress Label will be displayed in the printer´s LC Display when the label is recalled from
the optional memory card. The printer „looks" into each label on the memory card and
controls if an alternative Label description is available. This description is shown instead
of the original label name which is limited to 8 characters.
This optional text will be displayed on the printers LC Display
instead of the original filename when it is recalled from the
optional memory card. Maximum length is 16 characters.
242
242