Chapter 1: Introduction; Introduction; Nomenclature, Syntax Of The Commands - CAB A+ Series Programming Manual

Chapter 1: Introduction

11

Introduction

IMPORTANT
• The described commands and sequences are tested and approved with original cab printers.
cab Produkttechnik can not guarantee that all functions are available on OEM products.
• All sample labels are created with a 300 dpi printer,
• All measurements are in millimeters for the usage in international markets. Label positions have to be
recalculated if the printer is set to „country = USA", if no measurement command is transmitted.
• Some described functions are only available if your printer contains the actual firmware. We
recommend to download and install the actual firmware release from our website at:
• We tried our best to write an easy understandable programmer´s manual which should contain every
possible function of cab printers.
Multiple different methods have been used to make sure that every shown example works properly and
a few proof reads have been done to avoid any error in this manual.
Nevertheless - we would appreciate your comments, where more explanation is required and where we
have to do things better. Every comment is welcome and will influence our future work.
And if you find any error,- then please let us know. Thank you for your help !

Nomenclature, Syntax of the commands

• All commands are accepted when the line end identifier is transmitted, with the exception of ESC
commands, they are processed as soon as the required character is received.
• Carriage returns are not displayed in the headlines and not in the example files of this manual, to
keep a better overview. Carriage Returns (ASCII 13, HEX 0D) are only shown in the syntax description
in italic letters (CR ).
You may use either CR (carriage return), LF (line feed) or CR/LF (carriage return/ line feed)
(See also the ASCII table in the APPENDIX of this manual)
• It is not required to use special characters to create a label format. Data can be keyed in with a simple
text editor.
• For a better overview it is allowed to add spaces or tabs within a command line. Numeric parameters
accept additional zeros.
• Separators for the parameters are either semicolons or commas.
cab Produkttechnik GmbH & Co KG
: We highly recommend to read the introduction first !!
http://www.cabgmbh.com
11
11