I - Image Field Definition - CAB A+ Series Programming Manual

239

I - Image Field Definition

The I command is used for image printing. ( Image stands for pictures, pictograms, logos etc.).
It defines the position and the size of an image on the label.The image has to be downloaded first,
before it can be placed on the label. (See „d" - download command for more details )
Syntax:
cab Produkttechnik GmbH & Co KG
I[:name;]x,y,r[,mx,my, GOODBADn][,a];name CR
I = Image field definition
[:name;] = describes the field name and is optional. The maximum
length of this name is 10 characters, no special characters
allowed. A field name can be used for further operations, such
as replacements etc. (See „R" command for details).
X = The x - coordinate is the horizontal start position of an image (in
millimeters or inches), the distance between the left margin of a
label and the upper left corner of the image.
y = The y - coordinate is the vertical start position of an image, the
distance between the top margin of a label and the upper left
corner of the image.
The maximum coordinate depends on the printer type. Please
refer to the operator´s manual.
r = Rotation -rotates an image in 4 directions. Valid values are 0, 90,
180 and 270. Measurement in degrees.
mx = Horizontal magnification factor. Values 1-10. This parameter is
optional. Enlarges the image horizontally multiplied by this factor.
my = Vertical magnification factor. Values 1-10. This parameter is
optional. Enlarges the image horizontally multiplied by this factor.
GOODBADn = Used to check the image with the optional barcode verifier. The
verifier checks for "Good read" or" Bad read).This is helpful for
barcodes with complex contents such as EAN 128.
a = Autoload -allows to recall a picture from memorycard.The printer
leaves the field empty if no picture has been found.
It is required to set the values for mx and my, when Autoload is
used ! Please see also the examples on the next pages.
239
239