P - Set Peel-Off Mode - CAB A+ Series Programming Manual

258

P - Set Peel-Off Mode

This command needs an optional peel off sensor, which varies from printer type to printer type.
This command pauses the printer after each label. The next label prints, when the actual label is
removed.
The P command is very important if an applicator is used.
Syntax:
The „P" command needs to be placed after the definition of the page size ! („S"- command)
cab Produkttechnik GmbH & Co KG
P[disp] CR
P - Peel-Off Mode command.
disp = displacement in millimeters or inches (optional parameter)
positive and negative values can be used, depending in which
direction the displacement should work.
258
258