Software Upgrade Wizard - AudioCodes mediapack MP-500 User Manual

3. Click the Load File button corresponding to the file you want to load.
4. Repeat steps 2 through 3 for each file you want to load.
5. To save the loaded auxiliary files to flash memory, refer to ''Saving Configuration'' on
page 237.
6. To reset the device (if you have loaded a Call Progress Tones file), refer to ''Resetting
the Device'' on page 235.
3.5.2.2

Software Upgrade Wizard

The Software Upgrade Wizard allows you to upgrade the device's firmware (cmp file) as
well as load an ini file and/or auxiliary files (e.g., Call Progress Tones). However, it is
mandatory, when using the wizard to first load a cmp file to the device. You can then
choose to also load an ini file and/or auxiliary files, but this cannot be pursued without first
loading a cmp file. For the ini and each auxiliary file type, you can choose to load a new file,
or not load a file but use the existing file (i.e., maintain existing configuration) running on the
device.
The Software Upgrade Wizard allows you to load the following files:
cmp: (Mandatory) compressed firmware file
Optional files:
•
ini: configuration file
•
Data: data routing configuration file
•
Auxiliary files: CPT (Call Progress Tone), PRT (Prerecorded Tones), FXS
Coefficient,and USERINF (User Information)
Warnings:
SIP User's Manual
•
To preserve your data configuration settings, before upgrading the
device, save a copy of the device's data configuration settings to your
PC. After you have upgraded the device, restore your data configuration
settings by uploading the Data file to the device. For saving and restoring
configuration, refer to Backing Up and Restoring Configuration on page
244.
•
To preserve all configuration settings, before upgrading the device to a
new major software version (e.g., from version 5.6 to 5.8), save a copy of
the device's configuration settings (i.e., ini file and data file) to your PC
and ensure that you have all the original auxiliary files (e.g., CPT file)
currently used by the device. After you have upgraded the device, restore
your configuration settings by uploading these files to the device. For
saving and restoring configuration, refer to ''Backing Up and Restoring
Configuration'' on page 244.
•
The Software Upgrade Wizard requires the device to be reset at the end
of the process, which may disrupt traffic. To avoid this, disable all traffic
on the device before initiating the wizard by performing a graceful lock
(refer to Saving and Resetting the Device).
240
MP-500 MSBG
Document #: LTRT-12801