Brother 09055CDN Service Manual page 472

■ Change of the transfer current setting (Only for Japanese hagaki printing)
<Function>
Dots appeared when hagaki printing is performed can be alleviated by changing the transfer
current setting.
<Operating procedure>
(1) Press the 4 and 5 buttons in this order in the initial state of the maintenance mode.
The "Special Printing" appears on the LCD.
(2) Press the or
There are four setting options: "Default", "HAGAKI1", "HAGAKI2", and "HAGAKI3".
("*" is displayed at the end of the currently specified function in the LCD display.
The initial value is "Default".)
(3) "Accepted" is displayed on the LCD, and the machine goes back to the initial state of the
maintenance mode.
(4) Perform hagaki printing again to check if the dot symptom is alleviated.
(5) If not, repeat the steps (1) and (2) to set an optimum option, and then perform hagaki
printing.
button to change the setting, and press the OK or Start/Black button.
5-34
Confidential