Paper Feeding Problems; No Feeding - Brother 09055CDN Service Manual

3.5

Paper Feeding Problems

Problems related to paper feeding are end user recoverable if following the User Check items.
If the same problem occurs again, follow each procedure in the order of the number described
in the Step column in the tables below.
3.5.1

No feeding

■ Paper fails to be supplied from the paper tray 1 (Error code 27, etc)
<User Check>
- Check if the Tray Use setting is fixed to other tray.
- Check if the paper is loaded into the paper tray 1 correctly.
- Check if the loaded paper is smaller than the specified size.
- Turn back the paper loaded in the paper tray 1 or change the orientation of the paper by 180°.
- Adjust the paper guide in accordance with the paper size.
- Check if the thickness of the paper is 60 to 105 g/m
Step
1
2
3
4
5
6
7
8
9
10
Engine PCB ASSY
PF drive motor
Cause
T1 paper edge actuator malfunction
Harness connection failure of
PF drive motor
Installation failure of roller holder
ASSY
T1 paper pick-up roller worn out
T1 paper edge sensor failure
Plate gear damaged
T1 solenoid ASSY failure
PF drive motor failure
Engine PCB failure
Main PCB failure
T1 solenoid ASSY
2
.
Re-assemble the T1 paper edge actuator.
Check the harness connection of the PF
drive motor and reconnect it.
Check the installation of the roller holder
ASSY and reinstall it correctly.
Replace the paper feeding kit1.
Check the sensor performance following
the procedure described in
32". If any problem occurs, replace the T1
paper edge sensor PCB ASSY.
Replace the paper tray 1.
Replace the T1 solenoid ASSY.
Replace the PF plate ASSY.
Replace the engine PCB ASSY.
Replace the main PCB ASSY.
Plate gear
Fig. 2-14
2-103
Remedy
"Function code
Registration front actuator
T1 registration front/rear
sensor PCB
Roller holder ASSY
Confidential