Frame Pattern Print (Two-Sided) (Function Code 70) - Brother 09055CDN Service Manual

Color laser mfc
Table of Contents

Advertisement

1.4.23 Frame pattern print (Two-sided) (Function code 70)

<Function>
This function allows you to print one page of the frame pattern of the external circumference in
two-sided printing and check if there is any deviation or omission of print.
<Operating procedure>
(1) Load Letter-size paper on the paper tray.
(2) Press the 7 and 0 buttons in this order in the initial state of the maintenance mode.
"PRINTING" is displayed on the LCD, and one page of the frame pattern (refer to the
figure below) in two-sided printing. When print is completed, "WAKU DX" is displayed on
the LCD.
Note:
When printing fails, a relevant error is displayed on the LCD. Remove the cause of
error and press the Start/Black button, and the product automatically goes back to the
executable state, and "WAKU DX" is displayed on the LCD. Press the OK button, and
"PRINTING" is displayed on the LCD, and one page of the frame pattern is printed in
two-sided printing.
(3) Press the Stop/Exit button to return to the machine to the initial state of the maintenance
mode.
When an error message is displayed on the LCD, take the measures described in the
table below.
Error message
TONER EMPTY # *
Cover is Open
No Paper
Jam Tray1
Jam Rear
* # indicates the toner color (K, Y, M, or C) of which cartridge became empty.
(First side)
Replace the empty toner cartridge and press the Start/Black
button to clear the error.
Close the front cover.
Replenish the letter-size paper in the tray and press the
Start/Black button to clear the error.
Remove the jammed paper, and press the Start/Black
button to clear the error.
(Second side)
Fig. 5-27
5-51
Measure
Confidential

Advertisement

Table of Contents
loading

Table of Contents