How To Enter The End User-Accessible Maintenance Mode - Brother 09055CDN Service Manual

1.2 How to Enter the End User-accessible Maintenance
Mode
Basically, the maintenance-mode functions listed in the
service personnel only. However, you can allow end users to access some of these under the
guidance of service personnel by phone, for example.
The end user-accessible functions are shaded in the table given on the
09, 10, 11, 12, 25, 43, 45, 52, 53, 54, 66, 68, 71, 72, 77, 80, 82, 87, 88
Function code 10 accesses the firmware switches, each of which has eight selectors.
The service personnel should instruct end users to follow the procedure given below.
■ Non Touch panel model
<Operating procedure>
(1) Press the Menu, Start/Black, Menu and
the ready state. "MAINTENANCE 06" appears on the LCD.
(2) Press the
press the OK button.
To switch the machine back to the ready state, press the Stop/Exit button. When each of the
user-accessible functions is completed, the machine automatically returns to the ready state.
■ Touch panel model
<Operating procedure>
(1) While the machine is in the ready state, press the COPY and SCAN buttons at the same
time, and press the Start/Black button, then press the COPY and SCAN buttons at the
same time.
(2) Enter the maintenance mode that you want to use using the ten-key pad.
To switch the machine back to the ready state, press the Stop/Exit button. When each of the
user-accessible functions is completed, the machine automatically returns to the ready state.
or button to display the desired maintenance code on the LCD. Then
"0" is displayed on the LCD.
next page
buttons in this order when the machine is in
5-2
should be accessed by
next page.(codes
and 91)
Confidential
06,