Maintenance Mode; How To Enter The Maintenance Mode - Brother 09055CDN Service Manual

1.

MAINTENANCE MODE

The maintenance mode is exclusively designed for the checking, setting and adjustments of
the machine by using the buttons on the control panel. The EEPROM can be customized
according to the destination of the machine. Moreover, the operational check of the LCD,
operation panel board, and sensors, print test, display of the log information and error codes,
and change of the worker switches (WSW) can be performed.
1.1

How to Enter the Maintenance Mode

■ Non Touch panel model
<Operating procedure>
(1) Press the Menu button and then the Start/Black button while the machine is in the ready
state. Next, press the
Memo:
Operation using Menu, *, 2, 8, 6 and 4 buttons is also available.
(2) The machine beeps for one second and displays "
indicating that it is placed in the initial state of the maintenance mode, a mode in which the
machine is ready to accept entry from the buttons.
(3) To select any of the maintenance mode functions shown in the
maintenance mode that you want to use using the ten-key pad.
Memo:
- To exit from the maintenance mode and switch to ready state, press the 9 button twice in
the initial state of the maintenance mode.
- When the Stop/Exit button is pressed, the machine beeps for one second and returns to
the initial state of the maintenance mode.
- When an incorrect maintenance mode is entered, the machine beeps for one second and
returns to the initial state of the maintenance mode.
■ Touch panel model
<Operating procedure>
(1) While the machine is in the ready state, press the COPY and SCAN buttons at the same
time, and then press the *, 2, 8, 6 and 4 buttons in this order.
(2) The machine beeps for about one second and displays "
touch panel, indicating that the machine enters the initial state of the maintenance mode.
(3) To select any of the maintenance mode functions shown in the
maintenance mode that you want to use using the ten-key pad.
Memo:
- To exit from the maintenance mode and switch to ready state, press the 9 button twice in
the initial state of the maintenance mode.
- When the Stop/Exit button is pressed, the machine beeps for one second and returns to
the initial state of the maintenance mode.
- In the maintenance mode, the functions are assigned to the buttons on the operation
panel as shown in the table below.
Pressing the SCAN and COPY buttons at the same time
SCAN button
COPY button
Print Data button
Since the buttons assigned to these functions are not included in the detailed description of
each maintenance mode for the touch panel model, be sure to check the above table to use
the assigned buttons.
button four times to enter the maintenance mode.
Button on operation panel
Menu button
OK button
5-1
" on the LCD,
next page, enter the
" on the
next page, enter the
Assigned function
button
button
Confidential