Brother 09055CDN Service Manual page 113

■ Error code 97
Size mismatch
Reload correct paper.
A paper size, which is not supported by the paper tray 1, is specified in the paper size of the
data.
Error code 98
Size mismatch
Reload correct paper.
A paper size, which is not supported by the paper tray 2, is specified in the paper size of the
data.
Error code 99
Size mismatch DX
Press Job Cancel. Specify the correct paper and load the same size paper as
the machine driver setting.
The tray in which unsupported paper size is loaded is selected for duplex printing.
Error code 9A
Manual Feed
Load Paper
No paper is loaded in the MP tray. (MP paper empty sensor fails to be turned ON.)
This error does not usually occur in the normal use. The conceivable causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
<User Check>
- Turn OFF the power switch, and turn it ON again after a while.
Step
1 Main PCB failure
Cause
2-74
Remedy
Replace the main PCB ASSY.
Confidential