Double Feeding; Paper Jam - Brother 09055CDN Service Manual

3.5.2

Double feeding

<User Check>
- Check if too much paper is not loaded in each paper tray.
- Check if paper is properly loaded in each paper tray.
- Turn back the paper loaded in the each paper tray or change the orientation of the paper by 180°.
- Check if the thickness of the paper is 60 to 105 g/m
- Set out papers and reload them into the paper tray.
Step
1
3.5.3

Paper jam

■ Paper jam at the paper tray 1 (Error code 8A)
<User Check>
- Check if the paper is loaded into the paper tray 1 correctly.
- Turn back the paper loaded in the paper tray 1 or change the orientation of the paper by 180°.
- Adjust the paper guide corresponding to the paper size.
- Check if too much paper is loaded in the tray.
- Check if the thickness of the paper is 60 to 105 g/m
Step
1
2
3
4
5
6
7
Cause
Abrasion of separation pad or
separation roller
Cause
Foreign object around paper tray
1
Harness connection failure of T1
registration front/rear sensor
PCB ASSY
Paper feeding kit1 worn out
Registration front actuator
malfunction
Registration front sensor failure
Engine PCB failure
Main PCB failure
2
. (60 to 163 g/m
Replace the appropriate paper feeding kit.
2
.
Remove the foreign object.
Check the harness connection of the
T1 registration front/rear sensor PCB
ASSY and reconnect it.
Replace the paper feeding kit1.
Re-assemble the registration front
actuator.
Check the sensor performance following
the procedure described in
32". If any problem occurs, replace the T1
registration front/rear sensor PCB ASSY.
Replace the engine PCB ASSY.
Replace the main PCB ASSY.
2-106
2
for the MP tray.)
Remedy
Remedy
"Function code
Confidential