Adjust Vr (Th)(Throttleajustvr); Operation Timer(Op-Timer); G Band(2.4Gband) - Ko Propo EX-1 Instruction Manual

Adjust VR (TH)(ThrottleAjustVR)

Adjust the throttle resistance to offset wear during use.
Numbers will change as the throttle trigger is moved slowly to full
forward and reverse positions. Release the trigger, then select
YES (press and hold ENTER) to adjust or NO to cancel and
return to the menu.
(Basic Operation p.15)
Do not operate throttle trigger while pressing ENTER, as this may
change the data values and affect subsequent operations. If this
function is not adjusted properly, improper operation may result.
VR Adjust timing may vary depending on usage. If problems persist
even after using VR Adjust, contact KO Propo Customer Service
Department to arrange repairs. (We recommend that you contact KO
Propo Customer Service Department if you are not sure what the
problem is.)

Operation Timer(OP-Timer)

Display the transmitter operation time.
Example
Use to check the battery replacement time or time until
maintenance is required.
Display Explanation
USER TIMER DISPLAY
Timer which shows how long the transmitter has been in use
by the user.
ELAPSED TIMER DISPLAY
Timer which shows total time the transmitter has been in
use since shipment from the factory.
Clear the User Timer by pressing and holding the ENTER key.
(Basic Operation p.15)
ALL RESET can also be used to clear User Timer.
ELAPSED TIMER cannot be cleared. However, there may be
instances such as damage or repairs which require it to be cleared.

2.4G Band(2.4GBand)

Use to conduct pairing or select FRANCE mode.
This product uses the FHSS transmission system, which switches
between frequencies in the2.4GHz range at a high speed. In order
to increase usability with other transmitters, FRANCE Mode and
GENERAL Mode are available. Select according to driving conditions.
Select the mode, then select [START] (press and hold ENTER
key) to confirm or begin pairing process.
(Basic Operation p.15)
See p.11 for pairing procedure details.
Setting Range ( :GENERAL)
Default
GENERAL
(Normal Mode)
Pairing is Required!
If the mode is changed, please conduct pairing procedures with
the receiver you are using again.
[Pairing Status]
Press ENTER key after pairing has completed to return to the
menu.
52
, FRANCE
(France Mode)