Power Management(Power Management); All Reset(Allreset); Ics(Ics); Approval - Ko Propo EX-1 Instruction Manual

Power Management(POWER
MANAGEMENT)
Select the type of battery used.
Select the appropriate choice.
Setting Range
DRY , NI-MH
(Alkaline Batteries)
LIPO , LIFE
(Li-Po Battery) (Li-Fe Battery)
According to the selected power source type, a low voltage warning
will be displayed. Transmitter signals will not be cut at this time,
but problems with control may be experienced. Stop operation
immediately and replace batteries.
Change Power Management After Switching Battery Type!
If the battery used does not match the Power Management setting,
the battery may be over-discharged and damaged. This may also
result in fire, so make sure you pay special attention.

All Reset(AllReset)

Delete all model data, function settings, system settings, etc.
and reset the transmitter to default factory settings.
Select [YES] (press and hold ENTER key) to reset and [NO] to
cancel and return to the menu.
How to Display the Setting Screen
From the System Menu, use the jog dial to select [AllRset].
Select [AllRset] by pressing the ENTER key to display the AllReset
screen.
Use the jog dial to select [YES].
To reset, press and hold ENTER key. To cancel, press BACK key or
select [NO].
Once reset, the previous data cannot be recovered, so be careful
to avoid undesired resets.
(Basic Operation p.15)
,
(Ni-MH Battery)
(Basic Operation p.15)

ICS(ICS)

Connect transmitter to a PC with ICS.
Example
Use when you wish to adjust the transmitter's data with a PC.
Select [YES] (press and hold ENTER key) to connect ICS.
Operation p.15)
How to Connect ICS
Prior to procedure, connect ICS USB Adapter HS (sold separately) to the
transmitter's ICS port.
ICS connection confirmation message will be displayed. Move the
cursor to select [YES].
Press and hold ENTER key.
If ICS connection status becomes (EXIT >> POWER OFF), you cannot
return to the System Menu screen.
The PC environment will be readied to allow transfers (data reading/
writing).
How to Disconnect ICS
Since you cannot return to the System Menu, confirm that all transfers
are complete and then switch off the transmitter.
If the maximum number of model data entries is reached (40
models), ICS is convenient to enable storage of model data on a
PC or switching of model data.
Check the instructions included with connection equipment for
information regarding PC or ICS environment settings.

Approval

Displays overseas product approvals.
53
See p.7 regarding ICS port.
(Basic