Steering Punch(St-Punch); Steering Reverse(St-Reverse); Travel Override(Travel Override) - Ko Propo EX-1 Instruction Manual

Steering Reverse(ST-Reverse)

This function reverses the steering direction. This setting screen
is common with the throttle.
Example
Use this function when, after installing the servo, movements
are the opposite of transmitter inputs (turning the steering wheel
right results in wheels turning left, etc.).
Setting Range ( :NOR)
Default
STEERING:REV , NOR
(Reverse)
THROTTLE:
see [Throttle Reverse]
Steering direction varies from car to car and should be checked
when the R/C equipment has been installed.
(Normal)

Travel Override(Travel Override)

Adjust the steering angle according to the driving conditions to
make the car easier to control.
Example
Convenient for changing the steering angle on straights to give
the car better straight-line stability.
Setting Range
KEY:OFF, ET1 - 5, BT1(
Assigns a key to be used to switch between the steering
travel/balance settings and the travel override.
TRAVEL:0 - 150( :100)
Default
Sets the travel override's travel setting.
BALANCE L:40 - 100%(
BALANCE R:40 - 100%(
Sets the balance of the travel override. R and L refer to the
balance when turning right and left respectively.
For detailed explanations of travel and balance, refer to
[Steering Travel]and [Steering Balance]
[SOR] Display on the Function Monitor!
Operating the key that is assigned by [KEY] will result in [SOR]
being displayed on the initial screen's function monitor. If that key
is pressed while at the initial screen, [SOR] will disappear from the
function monitor.
The setting value percentage is a ratio of the travel value set during
[Steering Travel].
Steering balance can be adjusted by using the steering wheel
and ET key!
When travel override is ON, if an ET key that is assigned to
steering trim is pressed while the steering is turned over halfway
in either direction the balance of the direction of the turn can be
adjusted.
However, this cannot be done while on the Function Menu or
System Menu screens.
24
:OFF)
Default
:70%)
Default
:70%)
Default