Throttle Auto-Start(Th-Autostart); Idle Up(Idleup) - Ko Propo EX-1 Instruction Manual

Throttle Auto-Start(TH-AutoStart)

This function sets the throttle output to a fixed level at startup,
regardless of how much the throttle trigger is pulled.
Example Launching from the starting line.
Setting Range
KEY:OFF, ET1 - 5, BT1(
Default
Assigns a key to be used to activate/deactivate the
Auto-Start Function.
TRG.P:5 - 100%( :5%)
Default
Sets the trigger position at which the function operates.
FORWARD:OFF - 100%(
Default
Sets the function's throttle position.
The function will not operate until the throttle trigger reaches the set
position.
When the throttle is released, the function is deactivated and the
throttle returns to normal operation.
If the key assigned to Auto-Start is pressed, [AUT] will be displayed
on the initial screen's function monitor. If this key is pressed while at
the initial screen, [AUT] will disappear from the function monitor.
Normally, full throttle is set for launching from the starting line.
However, tire and surface conditions may mean full throttle will not
be effective. Conduct tests and make adjustments
:OFF)
:OFF)

Idle Up(IdleUp)

Used to offset the throttle's neutral position.
Example
Raising the idling has the effect of improving a glow engine
car's launch performance. It is also useful for canceling the
neutral brake of a motor with strong cogging and preventing
engine stalls when glow engine cars enter the pit for refueling.
Setting Range
KEY:OFF, ET1 - 5, BT1(
Assigns a key to be used to activate/deactivate the Idle Up
Function.
BUTTON:TGLE, PUSH(
Sets the method of activation.
TGLE:If a key is assigned to Idle Up, press once to
activate (2 beeps) and press again to deactivate (1 beep).
PUSH:It is only activated controls are operated and is
deactivated when controls are released.
C.TRM: -100 - 100(
Default
Sets the amount of throttle neutral offset.
Throttle can be operated even when Idle Up is activated. The high
point and brake point do not change during this time.
If the key assigned to Idle Up is pressed, [IUP] will be displayed on
the initial screen's function monitor. If this key is pressed while at
the initial screen, [IUP] will disappear from the function monitor.
Please note that if the transmitter is switched on while Idle Up is
activated, a malfunction could occur.
33
:OFF)
Default
:TGLE)
Default
:0)