Colored Grip And Pad Replacement; Unit Connector; Charger Jack; Power Switch - Ko Propo EX-1 Instruction Manual

●Colored Grip and Pad Replacement
Users can choose to install grips and pads of other colors (sold
separately).
[How to Replace]
Remove the two screws on each side of the grip to detach the
grip plates, then attach the colored grip and pad.
Grip Plate
Screws
Colored Grip
Make sure the battery box or battery pack is removed before
replacing the colored grip and pad.
The tabs on the colored grip and pad are to be inserted into holes.
Note the direction.
Note direction of the of the colored grip and pad.
●Unit Connector
This product may be dismantled and therefore each unit
features their respective connectors. Dirty or damaged
connectors may result in malfunctions, so please handle them
carefully.
Connector Cover
Do not touch the unit connectors with your fingers. If connectors
become corroded due to grime, they may become inoperable.
If storing the transmitter in dismantled form, please remember
to attach the connector covers. After prolonged use, a black
residue may build up on the connectors. Use cotton swabs dipped
in cleaning alcohol to remove. KO Propo's Customer Service
Department also handles transmitter maintenance.
●Charger Jack
A rechargeable battery can be recharged via the charger jack.
[How to Recharge]
Colored Pad
Screws
Grip Plate
●Power Switch
This product features a safety lock. The Master Unit and Grip
Unit cannot be detached when the Power Switch is in the ON
position. Turn off the transmitter before dismantling.

Power Switch

8
Confirm that the power switch is in the OFF position. If only
using the Grip Unit, make sure that the connector cover is in
place.
Make sure the battery is securely connected. If the
connection is loose, the battery may not charge completely.
Securely connect the charger plug to the charger jack.
Begin charging using a current of less than 1A.
AC 100V Charger
(Available Soon)
Quick Charger (Sold Separately)
Make sure the power switch is in the OFF position when charging.
If only using the Grip Unit, make sure that the connector cover is in
place. A short circuit may occur if the connector makes contact with
metal and lead to a serious accident. Use a current of less than 1A to
charge. Do not connect/disconnect the battery during charging. Take
note of the charger plug's polarity in order to avoid damage.
Do not attempt to charge if using alkaline batteries. Doing so
may result in battery leakage or cracking which will damage the
transmitter.
[Discharging the Battery Pack]
If using a battery pack, please note that it cannot be discharged via
the charger jack. Remove the battery pack from the transmitter to
discharge it.