Amp Mixing Throttle Hold(Ampmix Hold); Amp Mixing High Point(Ampmix Hipoint); Amp Mixing Brake(Ampmix Brake) - Ko Propo EX-1 Instruction Manual

Amp Mixing Throttle
Hold(AMPMix HOLD)
This function adjusts the set speed used for (F HOLD) and (R
HOLD) selected in Amp Mixing Mode.
[F HOLD] adjusts the front wheel drive while [R HOLD] adjusts
the rear wheel drive.
This setting is activated when F HOLD or R HOLD mode is
selected.
Example May be used for rock crawlers, etc.
Setting Range -150 - 150%(
On glow engine cars, an overly high setting value or mistaking
the +/- value will increase load on the servo and lead to it being
damaged. Check carefully while adjusting.
On electric cars, a setting value that is too small may cause
problems with the ESC settings. Make adjustments starting from
the default setting (100).
:0%)
Default
Amp Mixing High Point
(AMPMix HIPOINT)
Adjusts the maximum amount of throttle to be applied to the
front wheels.
Equivalent to the [Throttle High Point] function.
This setting is activated when NORMAL, DIG, or R HOLD
mode is selected.
High Point Position (white square)
Brake Position (black square)
Setting Range 0 - 150%(
This makes it easy to adjust the amount of maximum throttle,
particularly on a glow engine car.
If the amp mixing high point is set low and the amp mixing trim
is set to a high value toward acceleration, the resulting throttle
movement may be extraordinarily small.
On glow engine cars, an overly high setting value will increase
load on the servo and lead to it being damaged. Check carefully
while adjusting.
On electric cars, a setting value that is too small may cause
problems with the ESC settings. Make adjustments starting from
the default setting (100).
Brake will not operate if the value is set to 0.

Amp Mixing Brake(AMPMix BRAKE)

Modify the maximum amount of reverse (brake) to be applied
to the front wheels.
Equivalent to [Throttle Brake] function.
This setting is activated when NORMAL, DIG, or R HOLD
mode is selected.
Brake Position (white square)
High Point Position (black square)
Setting Range 0 - 150%(
On glow engine cars, an overly high setting value will increase
load on the servo and lead to it being damaged. Check carefully
while adjusting.
On electric cars, a setting value that is too small may cause
problems with the ESC settings. Make adjustments starting from
the default setting (100).
Brake will not operate if the value is set to 0.
40
:100%)
Default
:100%)
Default